Weber Summit Gas Grill S-460 User Manual

43267 US 06/11/09LPENGLISH Gas Grill Built-In LP Gas Grill Installation Guide#43267s-460™s-660™YOU MUST READ THIS OWNER’S GUIDE BEFORE OPERATING YOUR

10assEMBlY7www.wEBEr.COM®

1111m CAUTION: Use two people to lift and install the Summit® Built-In frame assembly.A) Lift the frame assembly into the “island” structure openin

12S-460™S-660™1/4" (6.35 mm) Drill BitassEMBlY910www.wEBEr.COM®

13131AA) Apply a bead of silicone sealant (1) around the perimeter and front edges of the grill that are in contact with the “island” structure. Thi

14BaTTErY hOUsinG wirinG1 BLACK WIRE2 GREEN WIRE3 RED WIRE4 RED WIREm WARNING: Make sure that all control knobs are turned to the OFF position before

1515assEMBlY(1) (2) (3)Note: Secure wire to side panel.Requires 3 “D” alkaline batterie

16assEMBlY12S-460™ S-660™312151617www.wEBEr.COM®

1717S-460™ S-660™CABMatch HolderassEMBlY18www.wEBEr.COM®

181/4" (6.35 mm) Drill BitassEMBlYm ATTENTION! Before drilling any holes for the rear vent make sure the cookbox is flush with the front of the g

1919s-460™ s-660™assEMBlYs-460™s-660™2021www.wEBEr.COM®

21112abm DANGERFailure to follow the Dangers, Warnings and Cautions contained in this Owner’s Manual may result in serious bodily injury or death, or

20s-460™ s-660™s-660™s-460™assEMBlY2223www.wEBEr.COM®

2121assEMBlYs-460™ s-660™24www.wEBEr.COM®

22assEMBlY1225s-660™s-460™www.wEBEr.COM®

2323s-660™s-660™s-660™s-460™s-460™++AAA ++AAA ++AAA a- 1- 2- 2- 4The Weber Grill Out™ Handle Light has a “Tilt Sensor”: Lid up - ON / Lid Closed

24BUILT-IN GAS LINE LOCATIONSNote: Leave an access in the “island” structure for gas supply and regulator service that is not inside the grill structu

2525Table6.2(a)Maximum Capacity of Metallic Pipe in Cubic Feet of Gas per Hour for Gas Pressures of 2 psi or Less and a Pressure Drop of 0.3 Inch Wate

26Gas sUPPlYTYPICAL 20 LP PROPANE GAS SUPPLY INSTALLATIONThe remote tank enclosure kit provided with your Weber Built-In grill shall be used for insta

2727OPERATINGm WARNING: Only use the Weber® Tank Enclosure Kit outdoors in a well-ventilated area. Do not use in a garage, building, breezeway or any

28LOCATING YOUR LP TANK ENCLOSURE KITWhen determining a suitable location for your LP Tank Enclosure Kit installation, give attention to concerns such

2929484 2422Hose and regulator - 1Tank stand - 1Tank stand base - 1Tank Scale - 11/4-20 nut - 6Nylon washer - 121/4-20 x 1/2” bolt - 6Cylinder glide

33“ISLAND” STRUCTURE CONFIGURATION OPTIONS There are many available options for locating the major components of your Island structure.Your major comp

30MOUNTING THE LP TANK BRACKETMount the LP tank bracket to the right hand side of the enclosure opening using non corrosive hardware. Mounting holes a

3131CABDE1iiiivvCONNECT GAS SUPPLYA 58 inch (147.32 cm) corrugated gas line is supplied with the grill. This line needs to pass through the gas inlet

VENTILATIONm WARNING: Ventillation holes must be provided in the structure at the top and bottom to provide ventilation in the event of a gas leak.Ven

43311711226845cabbd3311711226845cabbdGENERAL CONSTRUCTION DETAILSSummit® Built-In unit and all other accessory units should be on site before construc

55ORParTs lisTs-660™s-460™www.wEBEr.COM®Lid - 1Cookbox - 1Lid - 1Cookbox - 1Front Frame Rail - 1Rear Frame Rail - 1Rear Panel Assembly - 1Bottom Shelf

6ParTs lisTs-660™s-460™s-660™s-460™www.wEBEr.COM®Flavorizer® Bars- 8- 12Stainless Steel Cooking Grates- 2- 3Collection Tray - 1Catch-Pan Holder - 1Cat

7712ADoor Stop Bracket (A) should be positioned as shown.assEMBlYm ATTENTION! Do not attach rear support screws and washers until Step #6.www.wEBEr.CO

8m ATTENTION! Do not fully tighten screws. Clips should slide freely when installed.assEMBlY34www.wEBEr.COM®

99BackassEMBlY56www.wEBEr.COM®